How can we help you today?

Solution home Portable Analysers

ACG+

Information regarding the use of the ACG+

ACG: How do I calibrate this unit?
The ACG sensors should be periodically calibrated at intervals deemed necessary for the monitoring application by exposing the sensor to gas of a known co...
Thu, 11 Oct, 2018 at 3:28 PM
ACG: How do I clean /replace the PID sensor?
The ACG PID (VOC) sensor lamp and electrode stack should be cleaned as required (recommended every 3 months), The lamp should be replaced after approximat...
Thu, 11 Oct, 2018 at 3:28 PM
ACG: How do I replace a flow adaptor o' ring?
The ACG flow adaptor o'rings should be replaced evey 6 years (or as required). This procedure is detailed in the ACG+ user manual.  We also have...
Thu, 11 Oct, 2018 at 3:28 PM
ACG: How do I replace the activated charcoal filter?
The ACG activated charcoal filter should be replaced annually. This procedure is detailed in the ACG+ user manual.  We also have created an instruct...
Thu, 11 Oct, 2018 at 3:28 PM
ACG How do I replace the CO sensor?
The ACG CO sensor should be replaced approximately every 2 years (or as required). This procedure is detailed in the ACG+ user manual.  We also have...
Thu, 11 Oct, 2018 at 3:28 PM
ACG+: How do I replace the dewpoint sensor?
The ACG dewpoint (water vapour) sensor should be factory calibrated/ exchanged every 2 years. This procedure is detailed in the ACG+ user manual.  W...
Thu, 11 Oct, 2018 at 3:28 PM
ACG+: How do I replace the O2 sensor?
The ACG O2 (oxygen) sensor should be replaced approximately every 2 years (or as required). This procedure is detailed in the ACG+ user manual.  We ...
Thu, 11 Oct, 2018 at 3:28 PM
ACG+: How do I install a bespoke configuration to the ACG+
This instruction is intended to be used by users under instruction of the Analox Support Team. When Analox provides a bespoke configuration it can be upl...
Fri, 18 Nov, 2016 at 1:37 PM